What does error #013 mean on zortrax 3D Printers?
Error #013 indicates an unexpected extruder temperature drop, meaning the thermocouple detected a temperature decrease during printing. Make sure the heater and thermocouple are connected to the hotend. The suggested solution is Extruder cable / heater and thermocouple / extruder PCB replacement.
What causes error #010 extruder heating error on zortrax M Series 3D Printers?
Error #010 suggests that the thermocouple cannot detect a temperature increase. The suggested solution is heater and thermocouple / extruder PCB replacement / extruder cable.
How to fix error #075 on zortrax M Series?
Error #075 indicates that your Z-SUITE software is not up to date. To resolve this, update Z-SUITE to the latest version and then prepare the file again.
How to solve error #101 no models on SD card on zortrax M Series?
Error #101 means the SD card is either unreadable/damaged or contains no models. Try saving the file again onto the SD card. If the problem persists, safely remove the card and use another one.
Why am I getting error #003 file error on my zortrax 3D Printer?
Error #003 indicates the file cannot be read or the SD card is damaged. To fix this, save the file again to the SD card. If the issue continues, safely remove the card and try another one.
What to do if print stopped due to SD card timeout on zortrax 3D Printers?
If your print stopped due to an SD card timeout, it suggests the card is unreadable or damaged. Try saving the file to the SD card again. If that doesn't work, safely remove the card and use a different one.
How to fix error #002 SD card reading error on zortrax M Series 3D Printers?
Error #002 indicates an issue with the SD card. To resolve this, save the file to the SD card again. If the problem persists, safely remove the card and try using a different one.
What to do if my zortrax 3D Printer doesn't load material into the extruder?
If your printer isn't loading material, first ensure that the material hasn't run out. If it has, replace the spool and restart the print. Also, check for tangles on the spool or blockages near the material guide inlet; if found, unload the material, cut off the problem area, reload, and restart. Verify the spool is correctly secured on the holder, allowing proper rotation. Ensure the material isn't faulty with swells. Clean the extruder and hotend of any material remains, especially the extruder motor rack and nozzle, using the provided tools. Finally, ensure the material end is cut at a right angle; cutting it at an acute angle can ease loading.
General| Nozzle Diameter | 0.4 mm |
|---|---|
| Software | Z-SUITE |
| Extruder Type | Single |
| Heated Bed | Yes |
| Build Volume | 200 x 200 x 180 mm |
| Supported Materials | Z-ABS, Z-ULTRAT, Z-GLASS, Z-HIPS, Z-ESD, Z-PETG |
| Operating System Compatibility | macOS, Windows |
To Next Page
