Installing the microSDHC
™
Card (not included)
The microSDHC card can be installed and removed
while the phone is turned on. Unmount the microSDHC
card before removing or replacing it.
1. Insert the tray eject tool or the end of a small paper
clip into the hole beside the microSDHC card tray
(the upper one).
2. Pull out the microSDHC card tray and place the
microSDHC card (contacts facing down) on the tray
as shown. Then carefully replace the tray.
Note: Some applications may require a microSDHC card
to work normally or may store certain data on it. Therefore,
it is recommended that you keep a microSDHC card
installed and not remove or replace it randomly.
Charging the battery
Your phone’s battery should have enough power for the phone to turn on,
nd a signal, and make a few calls. You should fully charge the battery as
soon as possible.
If the battery is low, there will be a pop-up message on
the screen. As you charge your phone, the screen will
tell you the exact battery level each time you wake up
your phone.
If the battery is extremely low, you may be unable to
power on the phone even when it is being charged. In
this case, try again after charging the phone for at least
10 minutes. Contact customer service if you still cannot
power on the phone after prolonged charging.
9GETTING STARTED8 GETTING STARTED
1. Insert the charger’s connector into the charging port. Be sure to insert
the connector in the correct orientation. Do not force the connector into
the port.
2. Plug the charger into a standard AC wall outlet.
3. When the battery is fully charged, unplug the charger and disconnect it
from the phone.
Warning! Use only ZTE-approved chargers and cables. The use of unapproved
accessories could damage your phone or cause the battery to explode.
Caution: Do not change the built-in rechargeable battery in your phone by
yourself. The battery can only be changed by ZTE or a ZTE authorized service
provider.
Extending the battery life
Active applications, screen brightness levels, Bluetooth and Wi-Fi usage and
GPS functionality can drain your battery. You can follow the helpful tips below
to conserve your battery power:
• Reduce the screen backlight time.
• Lower the screen brightness.
• Turn auto-sync, Wi-Fi, and Bluetooth off when not in use.
• Disable the GPS function when not in use. Most applications using this
function will periodically query the GPS satellites for your current location;
each query drains your battery.
Powering your phone on/off
Make sure the micro-SIM card is in your phone and the battery is charged.
• Press and hold the Power key to power on your phone.
To Next Page
Loading...
