Page 31 of 32
when plugged in.
• Physical damage to the antenna ports will render your device unusable and is
not covered by the manufacturer’s warranty.
• The internal battery is not replaceable by the end user. Return to your service
centre for repair.
• Do not disassemble the case to change the battery, do not disassemble or short
circuit the battery terminals.
• Do not dispose of the unit in a fire, the internal battery may explode.
• At the end of life of the equipment, return the product to a suitable recycling
agent such as Mobile Muster.
RF SAFETY INFORMATION
The Wi-Fi modem has an internal antenna. For optimum performance with
minimum power consumption do not shield the device or cover with any object.
Covering the antenna affects signal quality and may cause the modem to operate
at a higher power level than needed.
RADIO FREQUENCY ENERGY
The Wi-Fi modem is a low-power radio transmitter and receiver. When switched
on it intermittently transmits radio frequency (RF) energy (radio waves).
The transmit power level is optimized for best performance and automatically
reduces when there is good quality reception.
Maximum power is only used at the edge of network coverage so under most
circumstances the power output is very low.
Under poor network conditions the modem transmits at a higher power level and
may get hot.
DECLARATION OF CONFORMITY – SPECIFIC ABSORPTION RATE (SAR)
The Wi-Fi modem is designed to be used in close proximity to the body. We
declare that the product detailed in this manual, and in combination with our
accessories, conform with the essential requirements of The Radio
Communications Standard (Electromagnetic Radiation Human Exposure) 2003 and
the Australian Communications and Media Authority Section 376 of the
Telecommunications Act 1997 when used at a distance of not less than 10mm
from the body. The worst case SAR result is 1.458W/Kg (10g average) with 10mm
spacing in the Body position. The limit is 2.0W/Kg
N14945
To Next Page
Loading...
