EasyManua.ls Logo

Zte MF910 - POWER UP YOUR WI-FI HOTSPOT

Zte MF910
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 5 of 32
Typical charging time is 3-4 hours using the standard charger. Charging from a
USB source (ie laptop) will take longer.
During periods of high continuous activity with multiple users, high download
rates or low network signal, charging by USB will not have sufficient current to
charge the device. In this situation the battery will discharge so it is preferable
to use the mains charger.
Always insert and remove the charging lead with care and take care not to trip
or pull on the lead harshly which could damage your device.
Physical damage to the charging port is not covered by warranty.
If the device is off while charging, press the power key as normal to switch on
the device.
The device can be left always on and connected to the charger if required.
During periods of high continuous activity, high download rates or low network
signal it is normal for the device to get hot.
If the internal temperature of the device exceeds 45C then the battery cannot
be charged due to safety limitations with Li-ion batteries.
POWER UP YOUR 4G WI-FI HOTSPOT
Press and hold the Power key for 1-2 seconds until the display lights up.
The Wi-Fi hotspot will be available after about 20 seconds.
Check the condition of your Wi-Fi hotspot as shown by the display.
To switch your device Off, press and hold the power key for 5 seconds until the
display starts to shut down.

Other manuals for Zte MF910

Related product manuals