Zte Spro2 - Adjusting the Projection

34
There are several ways that you can turn on or off the projector.
 When your Spro2’s screen is turned on, swipe up or down using
THREE fingers on the screen to turn on or off the projector.
 Drag the status bar down from the top of the screen and touch
Projector below Control Switch.
 From the HOME tab of the home screen, touch the round button
on the Projector widget.
 From the SETTINGS tab of the home screen, touch Projector >
Control and then touch the switch next to Projector in the
Projector settings screen.
NOTE:
For best results, project onto a non-reflective white flat display surface
at a 90° angle to Spro2’s touch screen. The projection distance of
Spro2 is about 3 to 12 feet.
Adjusting the Projection
When the projector is on, you can adjust projection focus, keystone
distortion and projection brightness.