Confidential and Proprietary Information of ZTE CORPORATION 15
MAC Address: Set the MAC address that are approved to connect to this Wi-Fi hotspot.
Click Apply to confirm your configuration.
WPS
Select Settings > Wi-Fi Settings > WPS, the WPS configuration is shown in the following figure:
PIN
：Enter the client PIN.
PBC
：
1. Select the PBC mode in the client WPS UI.
2. Select PBC mode in the WPS page of the device and then click Apply.
3. Press the WPS key to active your device’s WPS.
4. Please press the "next" key on the client WPS UI. After a few seconds the client can access
the Wi-Fi, and the result will be shown in the client WPS UI.
To Next Page
Loading...
