98
GETTING STARTED USING YOUR Z723EL
Device Installation
The Z723EL works with your wireless service provider’s cellular network instead
of your home’s phone jacks.
Position your Z723EL in a location that has a strong signal, typically near a
window or outside wall.
Power On or O
• To power on your Z723EL, slide the Power Switch
to the On position.
• To power o, slide the Power Switch to the O position.
Connect Your Z723EL to a Phone
Using a phone cable (not included), connect your home phone to
the PHONE 1 port.
Note: The PHONE 2 port can be used to connect an additional phone or
cordless base station. All telephones connected to the Z723EL will share the
same telephone number.
Note: When powered o, the Z723EL will not send or receive calls.
To Next Page
Loading...
