Zte ZXDSL 831A II - 3.2 Hardware Connection

ZXDSL 831AⅡ User’s Manual
7
LED No. Color Status Note
On The USB interface is in the communication status
Off
The Ethernet interface is in the non-communication
status
Flash Data is received or sent on the Ethernet interface
Ethernet Green
On The Ethernet interface is in the communication status
Rear panel
Figure 3.1-2 Rear Panel of the ZXDSL 831AⅡ
Table 3.1-2 Description of Interfaces on the Rear Panel
Item Introduction
DSL
RJ-11 connection interface: The equipment is connected to the ADSL line or
splitter via the telephone line.
USB
USB connection interface: Connect it to the PC computer using the USB
cable.
Reset
In the power-on state, you can restore the system to the default configuration
by using a thin needle to press this slot for five seconds
Ethernet
RJ-45 connection interface: Connect it to the PC computer or other network
devices using the network cable.
PWR Power interface. Connect it to the power adapter.
Power switch
3.2 Hardware Connection