ZXHN H168N User’s Manual
15
connect the phone set lines to the PHONE(or TEL)
interface of the splitter, and then connect the user
telephone cable port to the LINE interface of the splitter.
4 Connect the power
Connect one terminal of the power adapter to the
POWER interface of the ZXHN H168N, and the other
terminal to the socket on the wall, and then switch on the
power of the ZXHN H168N equipment.
Checking all connection cables
Check all connection cables following the below
procedure.
1 Check the DSL cable connection
If the DSL LED is on upon power-on of the ZXHN
H168N, it indicates that the DSL line is correctly
connected (Generally it takes one to two minutes to
perform the DSL connection).
2 Check the computer connection
If both the LINK LED on the computer adapter and the
Ethernet LED of the ZXHN H168N turn green, it
To Next Page
Loading...
