ZXHN H268A User Manual
Confidential and Proprietary Information of ZTE CORPORATION 7
Figure 3 The Back Panel
Table 3 describes the interfaces and buttons on the back panel of the ZXHN
H268A.
Table 3 The Back Panel
Interface/Button Function
DSL
RJ-11 port: It is used to connect to the VDSL2, or ADSL2+ uplink
access network.
Phone1~Phone2
RJ-11 port. It is used to connect to the phone through the telephone
line.
LAN1～LAN4
RJ-45 port. It is used to connect the modem to computer, STBs or
other network devices.
WAN RJ-45 port. It is used to connect to the network provided by the ISP.
WPS WLAN Protected Setup
Reset
During power on period, hold on this button for more than 5 seconds
to reset the current settings to the factory default setting, and then
the system automatically restarts.
WLAN WLAN switch. Turn on or turn off the WLAN.
Power Power supply port. It is connected to the power adapter.
Hardware Connection
Figure 4 shows the devices that are connected to interfaces of the ZXHN
H268A
To Next Page
Loading...
