AMG1202-T10B/AMG1302-T10B
Support Notes
22
All contents copyright © 2013 ZyXEL Communications Corporation.
Configuration
1. How do I configure the firewall?
You can use the Web Configurator to configure the firewall for AMG1302-T10B
/AMG1202-T10B. By factory default, if you connect your PC to the LAN
Interface of AMG1302-T10B/AMG1202-T10B, you can access Web
Configurator via ‘http://192.168.1.1’.
Note: Don’t forget to type in the Administrator Password.
2. How do I prevent others from configuring my firewall?
There are several ways to protect others from touching the settings of your
firewall.
1. Change the default Administrator password since it is required when
setting up the firewall.
2. Limit who can access to your AMG1302-T10B/AMG1202-T10B’s Web
Configurator or CLI. You can enter the IP address of the secured LAN
host in Web Configurator, Advanced Setup, Maintenance ->
RemoteMGNT to allow special access to your AMG1302-T10B
/AMG1202-T10B :
The default value in this field is 0.0.0.0, which means you do not care which
host is trying to telnet your AMG1302-T10B/AMG1202-T10B or access the
Web Configurator of.
3. Why can't I configure my AMG1302-T10B/AMG1202-T10B
using Web Configurator/Telnet over WAN?
There are four reasons that WWW/Telnet from WAN is blocked.
To Next Page
Loading...
