Is the egress rule configured correctly?
The egress rule indicates whether the packet going out the port should be
“tagged” or “untagged”. A port should generally be sending out untagged
packets if the port is directly connected to an end station
(PC, laptops, printers, etc.). However, if the port is connected to a neighboring
switch, or a device that has a virtual VLAN interface (IP phones, servers, routers,
etc.), then the port must send tagged packets.
Using Web GUI:
Figure 12 Advance%Application%>%VLAN%>%Index%
*Ports that are sending out tagged packets for this VLAN is labelled “T”.
Using CLI:
Figure 13 Enter CLI command “show vlan”
!
If a port on VLAN configuration is correct, go to <OTHERS>.
If a port on VLAN configuration is not correct, reconfigure and return to step 3.
To Next Page
Loading...
