Chapter 10 Home Networking
VMG/EMG/AM/DM/GM Series User’s Guide
255
10.6 STB Vendor ID
Use this screen to configure the Vendor IDs of connected Set Top Boxes (STBs) so the Zyxel Device can
automatically create static DHCP entries for them when they request IP addresses.
Click Network Setting > Home Networking > STB Vendor ID to open this screen.
Figure 128 Network Setting > Home Networking > STB Vendor ID
The following table describes the labels in this screen.
Subnet Mask Enter the public IPv4 subnet mask provided by your ISP.
Offer Public IP
by DHCP
Click this switch to enable the Zyxel Device to provide public IP addresses by DHCP server.
Otherwise, click to disable.
Enable ARP
Proxy
Click this switch to enable the Address Resolution Protocol (ARP) proxy. Otherwise, click to
disable.
Cancel
Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 63 Network Setting > Home Networking > Additional Subnet (continued)
LABEL DESCRIPTION
Table 64 Network Setting > Home Networking > STB Vendor ID
LABEL DESCRIPTION
Vendor ID 1 – 5 These are STB’s Vendor Class Identifiers (DHCP option 60). A Vendor Class Identifier is usually
used to inform the DHCP server a DHCP client’s vendor and functionality.
Cancel
Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
To Next Page
Loading...
