Chapter 6 Getting Start
GS1900 Series User’s Guide
56
Each field is described in the following table.
After clicking Ne xt, the set up your user name screen appears.
Fig ure 57 Getting Start > Start up > 2 Step 2 Set up user name/password
Each field is described in the following table.
After clicking Ne xt, the finish screen appears.
Table 13 Getting Start > Start up > 1 Step 1 Set up IP
LABEL DESCRIPTIO N
Host Name This field displays a host name.
IP Address The Switch needs an IP address for it to be managed over the network. The factory default
IP address is 192.168.1.1.
Subnet Mask The subnet mask specifies the network number portion of an IP address.
The factory default subnet mask is 255.255.255.0.
Gateway Type the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
DNS DNS (Domain Name System) is for mapping a domain name to its corresponding IP address
and vice versa. Enter a domain name server IP address in order to be able to use a domain
name instead of an IP address.
NTP (Network Time
Protocol)
This field displays the NTP time servers from which the Switch gets the time and date.
Next Click Ne xt to show the next screen.
Table 14 Getting Start > Start up > 2 Step 2 Set up user name/password
LABEL DESCRIPTIO N
Username The default user name is ad min and associated default password is 1234.
Password The default user name is a dm in and associated default password is 1234.
Previous Click Pre vious to show the previous screen.
Next Click Ne xt to show the next screen.
To Next Page
Loading...
