ZyXEL Communications GS2200-48 - Configure Rapid Spanning Tree Protocol

To Next Page

To Previous Page

Chapter 11 Spanning Tree Protocol

GS2200-48 User’s Guide

112

11.4 Configure Rapid Spanning Tree Protocol

Use this screen to configure RSTP settings, see Section 11.1 on page 105 for more

information on RSTP. Click RSTP in the Advanced Application > Spanning

Tree Protocol screen.

Figure 50 Advanced Application > Spanning Tree Protocol > RSTP

Main Page

About this User's Guide3
Document Conventions5
Safety Warnings7
Contents Overview9
- Table of Contents9
Table of Contents11
Introduction21
PART I Introduction21
Chapter 1 Getting to Know Your Switch23
- Introduction23
- Ways to Manage the Switch26
- Good Habits for Managing the Switch26
Chapter 2 Hardware Installation and Connection29
- Freestanding Installation29
- Mounting the Switch on a Rack30
- Hardware Overview33
Chapter 3 Hardware Overview33
- Front Panel Connections33
- Rear Panel36
- Leds38
Part II: Basic Configuration39
Basic Configuration39
Chapter 4 The Web Configurator41
- Introduction41
- System Login41
- The Status Screen42
  - Change Your Password47
- Saving Your Configuration48
- Switch Lockout48
- Resetting the Switch48
  - Reload the Configuration File49
- Logging out of the Web Configurator50
- Help50
Chapter 5 Initial Setup Example51
- Overview51
Chapter 6 System Status and Port Statistics57
- Overview57
- Port Status Summary58
  - Status: Port Details59
- Basic Setting63
Chapter 7 Basic Setting63
- Overview63
- System Information64
- General Setup66
- Introduction to Vlans68
- Switch Setup Screen69
- IP Setup71
  - IP Interfaces71
- Port Setup73
Part III: Advanced Setup77
- Vlan79
Advanced Setup77
Chapter 8 VLAN79
- Introduction to IEEE 802.1Q Tagged Vlans79
  - Forwarding Tagged and Untagged Frames79
- Automatic VLAN Registration80
  - Garp80
  - Gvrp80
- Port VLAN Trunking81
- Select the VLAN Type82
- Static VLAN82
- Subnet Based Vlans88
- Configuring Subnet Based VLAN89
- Protocol Based Vlans91
- Configuring Protocol Based VLAN92
- Create an IP-Based VLAN Example94
- Port-Based VLAN Setup95
  - Configure a Port-Based VLAN95
Chapter 9 Static MAC Forward Setup99
- Overview99
- Configuring Static MAC Forwarding99
- Filtering103
Chapter 10 Filtering103
- Configure a Filtering Rule103
Chapter 11 Spanning Tree Protocol105
- STP/RSTP Overview105
- Spanning Tree Protocol Status Screen110
- Spanning Tree Configuration111
- Configure Rapid Spanning Tree Protocol112
- Rapid Spanning Tree Protocol Status114
- Configure Multiple Spanning Tree Protocol116
- Multiple Spanning Tree Protocol Status119
- Bandwidth Control123
Chapter 12 Bandwidth Control123
- Bandwidth Control Overview123
  - CIR and PIR123
- Bandwidth Control Setup124
Chapter 13 Broadcast Storm Control127
- Broadcast Storm Control Setup127
- Mirroring129
Chapter 14 Mirroring129
- Port Mirroring Setup129
- Link Aggregation131
Chapter 15 Link Aggregation131
- Link Aggregation Overview131
- Dynamic Link Aggregation131
  - Link Aggregation ID132
- Link Aggregation Status132
- Link Aggregation Setting134
- Link Aggregation Control Protocol135
- Static Trunking Example136
- Port Authentication139
Chapter 16 Port Authentication139
- Port Authentication Overview139
  - IEEE 802.1X Authentication139
  - MAC Authentication140
- Port Authentication Configuration141
  - Activate IEEE 802.1X Security142
  - Activate MAC Authentication143
- Port Security145
Chapter 17 Port Security145
- About Port Security145
- Port Security Setup146
- Classifier149
Chapter 18 Classifier149
- About the Classifier and Qos149
- Configuring the Classifier149
- Viewing and Editing Classifier Configuration152
- Classifier Example155
- Policy Rule157
Chapter 19 Policy Rule157
- Policy Rules Overview157
  - Diffserv157
  - DSCP and Per-Hop Behavior157
- Configuring Policy Rules158
- Viewing and Editing Policy Configuration161
- Policy Example163
- Queuing Method165
Chapter 20 Queuing Method165
- Queuing Method Overview165
- Configuring Queuing167
- VLAN Stacking169
Chapter 21 VLAN Stacking169
- VLAN Stacking Overview169
  - VLAN Stacking Example169
- VLAN Stacking Port Roles170
- VLAN Tag Format171
  - Frame Format171
- Configuring VLAN Stacking173
- Multicast175
Chapter 22 Multicast175
- Multicast Overview175
- Multicast Status176
- Multicast Setting177
- IGMP Snooping VLAN179
- IGMP Filtering Profile181
- MVR Overview183
- General MVR Configuration185
- MVR Group Configuration187
  - MVR Configuration Example188
Chapter 23 Authentication & Accounting191
- Authentication, Authorization and Accounting191
  - Local User Accounts192
  - RADIUS and TACACS192
- Authentication and Accounting Screens192
- Supported RADIUS Attributes201
  - Attributes Used for Authentication201
  - Attributes Used for Accounting202
- IP Source Guard205
Chapter 24 IP Source Guard205
- IP Source Guard Overview205
- IP Source Guard209
- IP Source Guard Static Binding210
- DHCP Snooping213
- DHCP Snooping Configure217
  - DHCP Snooping Port Configure219
  - DHCP Snooping VLAN Configure220
- ARP Inspection Status222
  - ARP Inspection VLAN Status223
  - ARP Inspection Log Status224
- ARP Inspection Configure225
  - ARP Inspection Port Configure227
  - ARP Inspection VLAN Configure229
- Loop Guard231
Chapter 25 Loop Guard231
- Loop Guard Overview231
- Loop Guard Setup233
Part IV: IP Application235
- Static Routing237
IP Application235
Chapter 26 Static Routing237
- Configuring Static Routing237
- Rip239
Chapter 27 RIP239
- RIP Overview239
- Configuring RIP239
Chapter 28 Differentiated Services241
- Diffserv Overview241
  - DSCP and Per-Hop Behavior241
  - Diffserv Network Example242
- Two Rate Three Color Marker Traffic Policing242
  - TRTCM - Color-Blind Mode243
  - TRTCM - Color-Aware Mode243
- Activating Diffserv244
  - Configuring 2-Rate 3 Color Marker Settings245
- DSCP-To-IEEE 802.1P Priority Settings247
  - Configuring DSCP Settings248
- Dhcp249
Chapter 29 DHCP249
- DHCP Overview249
  - DHCP Modes249
  - DHCP Configuration Options249
- DHCP Status250
- DHCP Server Status Detail250
- DHCP Relay252
- Configuring DHCP VLAN Settings255
  - Example: DHCP Relay for Two Vlans257
- Vrrp259
Chapter 30 VRRP259
- VRRP Overview259
- VRRP Status260
- VRRP Configuration261
- VRRP Configuration Examples265
  - One Subnet Network Example266
  - Two Subnets Example267
Management269
Part V: Management269
- Maintenance271
Chapter 31 Maintenance271
- The Maintenance Screen271
- Load Factory Default272
- Save Configuration273
- Reboot System273
- Firmware Upgrade273
- Restore a Configuration File274
- Backup a Configuration File275
- FTP Command Line275
- Access Control279
Chapter 32 Access Control279
- Access Control Overview279
- The Access Control Main Screen279
- About SNMP280
- SSH Overview290
- How SSH Works291
- SSH Implementation on the Switch292
  - Requirements for Using SSH292
- Introduction to HTTPS292
- HTTPS Example293
- Service Port Access Control296
- Remote Management297
- Diagnostic299
Chapter 33 Diagnostic299
- Syslog301
Chapter 34 Syslog301
- Syslog Overview301
- Syslog Setup302
- Syslog Server Setup303
- Cluster Management305
Chapter 35 Cluster Management305
- Clustering Management Status Overview305
- Cluster Management Status306
  - Cluster Member Switch Management307
  - Uploading Firmware to a Cluster Member Switch309
- Clustering Management Configuration310
- MAC Table313
Chapter 36 MAC Table313
- MAC Table Overview313
- Viewing the MAC Table314
- IP Table317
Chapter 37 IP Table317
- IP Table Overview317
- Viewing the IP Table318
- ARP Table321
Chapter 38 ARP Table321
- ARP Table Overview321
  - How ARP Works321
- Viewing the ARP Table322
- Routing Table323
Chapter 39 Routing Table323
- Overview323
- Viewing the Routing Table Status323
- Configure Clone325
Chapter 40 Configure Clone325
Part VI: Product Specifications327
Product Specifications327
Chapter 41329
- Product Specifications329
Part VII: Appendices and Index337
Appendices and Index337
Appendix A IP Addresses and Subnetting339
- Introduction to Ip Addresses339
- Subnet Masks340
- Configuring Ip Addresses347
Appendix B Legal Information349
- Zyxel Limited Warranty351
Index353

ZyXEL Communications GS2200-48 - Configure Rapid Spanning Tree Protocol

Table of Contents

Related product manuals