Chapter 7 Wireless
LTE Series User’s Guide
111
Figure 77 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 34 Network Setting > Wireless > WPS
LABEL DESCRIPTION
General
WPS Click to enable ( ) and have the Zyxel Device activate WPS. Otherwise, it is disabled.
Add a new device with WPS Method
Method 1 PBC Use this section to set up a WPS WiFi network using Push Button Configuration (PBC). Click this
switch to make it turn blue. Click Apply to activate WPS method 1 on the Zyxel Device.
WPS Click this button to add another WPS-enabled WiFi device (within WiFi range of the Zyxel
Device) to your WiFi network. This button may either be a physical button on the outside of a
device, or a menu button similar to the WPS button on this screen.
Note: You must press the other WiFi device’s WPS button within two minutes of
pressing this button.
Method 2 PIN Use this section to set up a WPS WiFi network by entering the PIN of the client into the Zyxel
Device. Click this switch to make it turn blue. Click Apply to activate WPS method 2 on the Zyxel
Device.
To Next Page
Loading...
