Chapter 6 Broadband
LTE Series User’s Guide
91
6.5 Cellular WAN
Click Network Setting > Broadband > Cellular WAN to display the following screen. Use this screen to
enable data roaming and network monitoring when the Zyxel Device cannot ping a base station.
Note: APN information can be obtained from the service provider.
Roaming charges may apply when Data Roaming is enabled.
Automatic APN Mode is not supported when operating in 3G only mode.
Figure 62 Network Setting > Broadband > Cellular WAN
The following table describes the fields in this screen.
Table 22 Network Setting > Broadband > Cellular WAN
LABEL DESCRIPTION
Antenna
Antenna Select Select between External or Internal Antenna for your Zyxel Device.
Roaming
Data Roaming Click this to enable ( ) data roaming on the Zyxel Device.
4G roaming is to use your mobile device in an area which is not covered by your service provider.
Enable roaming to ensure that your Zyxel Device is kept connected to the Internet when you are
traveling outside the geographical coverage area of the network to which you are registered.
To Next Page
Loading...
Need help?
General
