ZyXEL Communications LTE Series - 4.7 Configure MAC Filter

Chapter 4 Tutorials
LTE Series User’s Guide
60
• Filter Name: Enter a name to identify the firewall rule.
• Source IP Address: Enter the IP address of the computer that initializes traffic for the application or
service.
• Select Destination IP Address: Enter the IP address of the computer to which traffic for the application
or service is entering.
• Protocol: Select the protocol (TCP, UDP or ICMP) used to transport the packets.
• Custom Source Port: Enter the port number/range of the source that define the traffic type.
• Custom Destination Port: Enter the port number/range of the destination that define the traffic type.
5 Select Enable Rate Limit to activate the rules you created. Click OK.
4.7 Configure MAC Filter
You can block certain web features and specific website addresses.
1 Go to the Configuration > Security > MAC Filter screen. Click Add New Rule.
2 Type the Host Name and the corresponding MAC Address that you want to block in the MAC Filter
screen.
3 Select the Active check box and click Apply.