Chapter 16 The Remote Management Screens
User’s Guide
186
16.3 Telnet
Click TOOLS > Remote Management > Telnet to control Telnet access to your
WiMAX Modem.
Figure 77 TOOLS > Remote Management > Telnet
The following table describes the labels in this screen.
16.4 FTP
Click TOOLS > Remote Management > FTP to control FTP access to your
WiMAX Modem.
Figure 78 TOOLS > Remote Management > FTP
Table 65 TOOLS > Remote Management > Telnet
LABEL DESCRIPTION
Server Port Enter the port number this service can use to access the WiMAX
Modem. The computer must use the same port number.
Server Access Select the interface(s) through which a computer may access the
WiMAX Modem using this service.
Secured Client
IP Address
Select All to allow any computer to access the WiMAX Modem using this
service.
Select Selected to only allow the computer with the IP address that
you specify to access the WiMAX Modem using this service.
Apply
Click to save your changes.
Reset Click to restore your previously saved settings.
To Next Page
Loading...
