48
Status
This displays Configured when the MWR102 has connected to a wireless
network using WPS. The current wireless and wireless security settings also
appear in the screen.
This displays Unconfigured if WPS is disabled and there are no wireless or
wireless security changes on the MWR102 or you click Reset to Unconfigured
to remove the configured wireless and wireless security settings.
Self-PIN Number
This displays a PIN number last time system generated. Click Generate to
generate a new PIN number.
Reset to
Unconfigured
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings
for WPS connections on the MWR102.
Push Button
Configuration
Press this button to begin the PBC process.
Current Key Info
The authentication type, encryption type, and key are displayed here if security
settings are configured.
Client PIN
number
This is where the PIN is displayed when using PIN setup. To generate a PIN,
press the Start PIN button.
Apply
Click Apply to save your changes back to the MWR102.
Refresh
Click Refresh to get this screen information afresh.
7.9 Wireless Site Survey (AP Mode Only)
Use this screen to view nearby wireless networks. Go to Wireless > Site Survey to open the
following screen.
Figure 20 Wireless > Site Survey
To Next Page
Loading...
