70
Figure 32 Management > Save/Reload Settings
The following table describes the labels in this screen.
Table 22 Management > Save/Reload Settings
LABEL DESCRIPTION
Save…
Click Save… to save the MWR102’s current configuration to your computer.
Load Settings
from File
Type in the location of the file you want to upload in this field or click Browse... to
find it.
Browse...
Click Browse... to find the file you want to upload. Remember that you must
decompress compressed (.ZIP) files before you can upload them.
Upload
Click Upload to begin the upload process.
Note: Do not turn off the MWR102 while configuration file upload is in
progress.
After you see a “configuration upload successful” screen, you must then wait one
minute before logging into the MWR102 again. The MWR102 automatically restarts
in this time causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
To Next Page
Loading...
