Chapter 16 Backup Planner
NAS Series User’s Guide
265
Figure 214 Backup Planner > Backup > Backup
The following table describes the labels in this screen.
Table 149 Backup Planner > Backup > Backup
LABEL DESCRIPTION
Add Job Click this to create and customize a backup job.
Edit Job Select a backup job in the list and click this to make some changes to it.
Activate Job Click this to enable the selected backup job.
Inactivate Job Click this to disable the selected backup job.
Delete Selected
Job(s)
Select a backup job in the list and click this to delete it.
Backup Now Select a backup job in the list and click this to run the backup job immediately.
Abort Job Select a backup job in the list and click this to stop the process if the backup job is currently
active.
Status This shows the current state of the backup job.
• Waiting means the backup job is not active but is scheduled to run at some time.
• Running indicates that the NAS is currently doing the backup job. When the backup job
is running, you can also see a progress bar.
• Inactivated means the backup job is disabled.
Job Name This identifies the backup job.
Source/Destination This shows the backup job’s source and target.
Type/Schedule This shows the backup type and frequency.
Backup Summary This shows the time it was last run in (and whether or not it succeeded), and when it is
scheduled to run again. The times use yyyy-mm-dd hh:mm:ss format.
To Next Page
Loading...
