Chapter 8 Control Panel: Network
NAS Series User’s Guide
145
Figure 113 Control Panel > Network > Terminal
The following table describes the labels in this screen.
8.7 DyDNS Screen
Use this screen to enable and configure Dynamic DNS.
Dynamic DNS (DyDNS) allows you to update your current dynamic IP address with a dynamic DNS
service so that anyone can contact you (such as through NetMeeting or CUSeeMe). You can also
access your FTP server or Web site on your own computer using a domain name (for instance
myhost.dhs.org, where myhost is a name of your choice) that will never change instead of using an IP
address that changes each time you reconnect. Your friends or relatives will always be able to call you
even if they don't know your IP address.
Click Control Panel > Network > DyDNS to open the following screen.
Table 84 Control Panel > Network > Terminal
LABEL DESCRIPTION
Enable Telnet
Service
Select this to enable Telnet access to the NAS. Clear it to not allow Telnet access to the NAS.
To use Telnet, log in as “admin” or “root” and use the admin password.
Enable SSH Service Select this to enable SSH access to the NAS. Clear it to not allow SSH access to the NAS.
To use SSH, log in as “admin” or “root” and use the admin password.
Apply Click this to save your changes.
Reset Click this to restore previously saved settings.
To Next Page
Loading...
