Chapter 21 Bandwidth Management
NBG6515 User’s Guide
137
21.3 What You Need To Know
The sum of the bandwidth allotments that apply to the WAN interface (LAN to WAN, WLAN to WAN)
must be less than or equal to the Upstream Bandwidth that you configure in the Bandwidth
Management Advanced screen (Section 21.5 on page 137).
The sum of the bandwidth allotments that apply to the LAN interface (WAN to LAN, WAN to WLAN)
must be less than or equal to the Downstream Bandwidth that you configure in the Bandwidth
Management Advanced screen Section 21.5 on page 137.
21.4 General Screen
Use this screen to have the NBG apply bandwidth management.
Click Management > Bandwidth Management to open the bandwidth management General
screen.
Figure 103 Management > Bandwidth Management > General
The following table describes the labels in this screen.
21.5 Advanced Screen
Use this screen to configure bandwidth management rules for the pre-defined services or
applications.
You can also use this screen to configure bandwidth management rule for other services or
applications that are not on the pre-defined list of NBG. Additionally, you can define the source and
destination IP addresses and port for a service or application.
Table 68 Management > Bandwidth Management > General
LABEL DESCRIPTION
Enable
Bandwidth
Management
This field allows you to have NBG apply bandwidth management.
Enable bandwidth management to give traffic that matches a bandwidth rule priority over
traffic that does not match a bandwidth rule.
Enabling bandwidth management also allows you to control the maximum or minimum
amounts of bandwidth that can be used by traffic that matches a bandwidth rule.
Apply Click Apply to save your customized settings.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
