Chapter 21 Bandwidth Management
NBG6515 User’s Guide
140
Figure 105 Bandwidth Management Rule Configuration: Application List
The following table describes the labels in this screen.
21.5.2 Rule Configuration: User Defined Service Rule Configuration
If you want to edit a bandwidth management rule for other applications or services, click the Edit
icon in the User-defined Service table of the Advanced screen. The following screen displays.
Figure 106 Bandwidth Management Rule Configuration: User-defined Service
Table 70 Bandwidth Management Rule Configuration: Application List
LABEL DESCRIPTION
# This is the number of an individual bandwidth management rule.
Enable Select an interface’s check box to enable bandwidth management on that interface.
Direction These read-only labels represent the physical interfaces. Bandwidth management applies to
all traffic flowing out of the router through the interface, regardless of the traffic’s source.
Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass through the NBG and be
managed by bandwidth management.
Bandwidth Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum or
minimum bandwidth allowed for the rule in kilobits per second.
Protocol This is the protocol (TCP, UDP or user-defined) used for the service.
OK Click OK to save your customized settings.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
