NBG6515 User’s Guide
142
CHAPTER 22
Remote Management
22.1 Overview
This chapter provides information on the Remote Management screens.
Remote Management allows you to manage your NBG from a remote location through the following
interfaces:
•LAN and WAN
•LAN only
•WAN only
Note: The NBG is managed using the Web Configurator.
22.2 What You Can Do
Use the WWW screen (Section 22.4 on page 143) to define the interface/s from which the NBG can
be managed remotely and specify a secure client that can manage the NBG.
22.3 What You Need to Know
Remote management over LAN or WAN will not work when:
1 The IP address in the Secured Client IP Address field (Section 22.4 on page 143) does not
match the client IP address. If it does not match, the NBG will disconnect the session immediately.
2 There is already another remote management session. You may only have one remote
management session running at one time.
3 There is a firewall rule that blocks it.
22.3.1 Remote Management and NAT
When NAT is enabled:
• Use the NBG’s WAN IP address when configuring from the WAN.
• Use the NBG’s LAN IP address when configuring from the LAN.
To Next Page
Loading...
