Chapter 22 Remote Management
NBG6515 User’s Guide
143
22.3.2 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
NBG automatically logs you out if the management session remains idle for longer than this timeout
period. The management session does not time out when a statistics screen is polling. You can
change the timeout period in the System screen
22.4 WWW Screen
To change your NBG’s remote management settings, click Management > Remote Management
> WWW.
Figure 107 Management > Remote Management > WWW
The following table describes the labels in this screen
Table 72 Management > Remote Management > WWW
LABEL DESCRIPTION
Enable Remote
WAN Access
Select this check box to enable Remote WAN Access.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Secured Client
IP Address
Select All to allow all computes to access the NBG.
Otherwise, check Selected and specify the IP address of the computer that can access the
NBG.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to begin configuring this screen afresh.
To Next Page
Loading...
