ZyXEL Communications NBG6515 - Chapter 7 Router Mode; 7.3 Status Screen; 7.1 Overview

NBG6515 User’s Guide
50
CHAPTER 7
Router Mode
7.1 Overview
The NBG is set to router mode by default. Routers are used to connect the local network to another
network (for example, the Internet). In the figure below, the NBG connects the local network
(LAN1 ~ LAN4) to the Internet.
Figure 39 NBG Network
Note: The Status screen is shown after changing to the Expert mode of the Web
Configurator. It varies depending on the device mode of your NBG.
7.2 What You Can Do
Use the Status screen (Section 7.3 on page 50) to view read-only information about your NBG.
7.3 Status Screen
Click to open the status screen.
Modem
Router