Chapter 1 Introduction
NBG6604 User’s Guide
12
Table 2 Buttons and Interface Behavior
Figure 2 Rear Panel
WLAN 2.4G White Amber On The WLAN interface is enabled.
Off The WLAN interface is disabled.
White blinking The NBG6604 is transmitting/receiving data.
Amber blinking The WPS process is in progress (at the same time, disable the
white LED).
Amber steady off The WPS process is inactive.
Note: When you connect the power, only the power/sys LED blinks. Others are off -> system ready ->
all LEDs follow their behavior described in this table.
FUNCTION LABEL DESCRIPTION/BEHAVIOR LOCATION
Power Jack DV IN
12v 1A
Connect the included power adapter. Rear
Reset/Restore Button Reset - Press the button for 5 or less than 5 seconds, system will
reboot.
- Press the button for more than 5 seconds, system will reset
configuration.
Rear
WPS Button - WPS button can trigger both 2.4G and 5G.
- WPS can work with 2.4G and 5G at the same time.
- WPS LED will be off while the device is connected to clients
(2.4G client or 5G client or both 2.4G/5G clients).
Top
Ethernet LAN LAN
WAN
WAN x1:
- RJ45 Connector
LAN x4:
- RJ45 Connector
Rear
Table 1 Top Panel LEDs (continued)
FUNCTION COLOR STATUS BEHAVIOR
LAN Ports 1-4
WAN Port
Power Input
Reset Button
WAN
LAN
DC IN
To Next Page
Loading...
