ZyXEL Communications NBG6604 - WAN Selection Type: Static

Chapter 3 eaZy 123 Wizard
NBG6604 User’s Guide
21
By implementing PPPoE directly on the NBG6604 (rather than individual computers), the computers on
the LAN do not need PPPoE software installed, since the NBG6604 does that part of the task.
Furthermore, with NAT, all of the LAN's computers will have Internet access.
Figure 10 WAN Selection Type: PPPoE
The following table describes the labels in this screen.
Note: If you get an error message, make sure you have entered the correct information
provided by your ISP.
3.3.3 WAN Selection Type: Static
Choose Static as the WAN Selection Type when the WAN port is used as a regular Ethernet. Click Next.
Table 6 WAN Selection Type: PPPoE
LABEL DESCRIPTION
WAN Selection Select the PPPoE (Point-to-Point Protocol over Ethernet) option for a dial-up connection.
PPPoE Username Type the user name given to you by your ISP.
PPPoE Password Type the password associated with the user name above.
Static IP (Optional) Enter the WAN IP address assigned by your ISP.