Chapter 16 Static Route
NBG6616 User’s Guide
127
Figure 84 Network > Static Route
The following table describes the labels in this screen.
16.2.1 Add/Edit Static Route
Click the Add Static Route button or a rule’s Edit icon in the Static Route screen. Use this screen
to configure the required information for a static route.
Figure 85 Network > Static Route: Add/Edit
Table 54 Network > Static Route
LABEL DESCRIPTION
Add Static Route Click this to create a new rule.
# This is the number of an individual static route.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Name This field displays a name to identify this rule.
Destination This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Modify Click the Edit icon to open a screen where you can modify an existing rule.
Click the Delete icon to remove a rule from the NBG6616.
Apply Click Apply to save your changes back to the NBG6616.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
