Chapter 11 Maintenance
NWA1120 Series User’s Guide
119
11.7 Firmware Upgrade Screen
Use this screen to upload a firmware to your NWA. Click Maintenance > Firmware Upgrade.
Follow the instructions in this section to upload firmware to your NWA.
Figure 62 Maintenance > Firmware Upgrade
The following table describes the labels in this screen.
Do not turn off the NWA while firmware upload is in progress!
Figure 63 Firmware Upload In Process
The NWA automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 64 Network Temporarily Disconnected
After the upload was finished, log in again and check your new firmware version in the Dashboard
screen.
Table 37 Maintenance > Firmware Upgrade
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Browse ... to find
it.
Browse... Click Browse... to find the .bin file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
To Next Page
Loading...
