NWA1120 Series User’s Guide 123
CHAPTER 12
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• NWA Access and Login
• Internet Access
• Wireless LAN
12.1 Power, Hardware Connections, and LEDs
The NWA does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the NWA.
2 Make sure the power adaptor or cord is connected to the NWA and plugged in to an appropriate
power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the NWA.
4 If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.7 on page 18.
2 Check the hardware connections. See the Quick Start Guide.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the NWA.
5 If the problem continues, contact the vendor.
To Next Page
Loading...
