Here we‟ll guide you to configure Address Mapping Sets from Web
Configurator and CLI. (Since in Web Configurator we can only edit the rules
for Address Mapping Sets #1. The other Address Mapping Sets #2~8 can only
be configured in CLI)
Now let's begin with Web Configurator:
Firstly let‟s come to Web Configurator, Advanced Setup, Network -> NAT ->
Address Mapping:
This menu is for Address Mapping Set #1, you can edit 10 Address Mapping
Rules for Set #1. You can edit or remove a rule by clicking the two buttons on
the rule table.
Click the „Edit’ Button on the rule #1, then you can enter the window in which
you can edit an individual rule and configure the Mapping Type, Local and
Global Start/End IPs: