P-660HN Series Support Notes
81
All contents copyright © 2010 ZyXEL Communications Corporation.
For example:
(1) If you need service PPPoE/LLC and Enet/LLC then the service bits will be
2+32 = 34 (decimal) = 22 (hex), you must input 22
(2) If you want to enable all service for VC hunting, the service bits will be
1+2+4+8+16+32=63(decimal)= 3f (hex), you must input 3f
Need to perform save after this by command „wan atm vchunt save‟
(3) Delete items from the auto-haunting preconfigured table by useing
command:
wan atm vchunt remove <remote node> <vpi> <vci>
15. How to configure packet filter on P-660HN-T1A?
The P-660HN-T1A allows you to configure up to twelve filter sets with six rules
in each set, for a total of 72 filter rules in the system. You can apply up to four
filter sets to a particular port to block multiple types of packets. With each filter
set having up to six rules, you can have a maximum of 24 rules active for a
single port.
To Next Page
Loading...
