ZyXEL Communications P-660HNU-T1 User Manual

Chapter 13 Static Route
ADSL Router Series User’s Guide
195
13.2.1 Static Route Edit
Use this screen to configure the required information for a static route. Select a static route index
number and click Edit. The screen shown next appears.
Figure 93 Advanced > Static Route: Edit
The following table describes the labels in this screen.
Table 66 Advanced > Static Route: Edit
LABEL DESCRIPTION
Static Route Setup
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.

ZyXEL Communications P-660HNU-T1 Specifications

Operating Environment

operating temperature	0°C to 40°C
operating humidity	20% to 90% RH
storage temperature	-25°C to 65°C
storage humidity	20% to 90% RH

Power

power input	12 VDC 1A

Ports & Interfaces

DSL port	One RJ-11 port for ADSL 2+
Ethernet ports	Four 10/100M Auto MDI/MDIX RJ-45 interface
USB port	One USB type A, 2.0 host USB

Weight and Dimensions

item dimensions (WxDxH)	186 x 121 x 33 mm
item weight	245 g
packing dimensions (WxDxH)	291 x 162 x 51 mm
packing weight	540 g