Chapter 1 Introducing the VMG
VMG4005-B50A/B60A User’s Guide
12
1.5 Hardware
This section describes the front and rear panels for each model. Refer to the VMG’s Quick Start Guides
to see the product drawings and how to make the hardware connections.
1.5.1 Front Panel
The LED indicators are located on the front panel.
Figure 4 Front Panel
1.5.2 LEDs (Lights)
None of the LEDs are on if the VMG is not receiving power.
Table 2 LED Descriptions
LED COLOR STATUS DESCRIPTION
Power
Green On The VMG is receiving power and ready for use.
Blinking The VMG is in the booting state and getting ready for use.
Red On The VMG detected an error while self-testing, or there is a device
malfunction.
Blinking The VMG is uploading firmware.
Off The VMG is not receiving power.
DSL1
DSL2
Green On The ADSL/VDSL line is up.
Blinking The VMG is initializing the ADSL/VDSL line.
Off The DSL line is down.
To Next Page
Loading...
