Chapter 1 Introducing the VMG
VMG4005-B50A/B60A User’s Guide
13
1.5.3 Bottom Panel
The connection ports are located on the bottom panel.
Figure 5 Bottom Panel
The following table describes the items on the bottom panel.
1.5.4 RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously. The password will be reset to the factory default (see the device label), and the
LAN IP address will be “192.168.1.1”.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for more than 5 seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults
have been restored and the device restarts.
Ethernet
Green On The VMG has a successful 10/100/1000 Mbps Ethernet connection with a
device on the Local Area Network (LAN).
Blinking The VMG is sending or receiving data to/from the LAN at 10/100/1000
Mbps.
Off The VMG does not have an Ethernet connection with the LAN.
Table 2 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
Rear Panel Ports
LABEL DESCRIPTION
DSL Connect a RJ-45 cable to the DSL port for Internet access.
LAN Connect a router/gateway to the Ethernet port for Internet access.
Reset Press the button to return the VMG to the factory defaults.
Power Connect the power adapter and then can press the power button to start the VMG.
To Next Page
Loading...
