ZyXEL Communications VMG9827-B50A - Page 26

Chapter 1 VMG Introduction
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User’s Guide
26
Table 3 VMG9827-B50A LED Descriptions
LED COLOR STATUS DESCRIPTION
Power
Green On The VMG is receiving power and ready for use.
Blinking The VMG is self-testing.
Red On The VMG detected an error while self-testing, or there is a device
malfunction.
Blinking The VMG is uploading firmware.
Off The VMG is not receiving power.
DSL1
DSL2
Green On The ADSL line is up.
Blinking The VMG is initializing the ADSL line.
Amber On The VDSL line is up.
Blinking The VMG is initializing the VDSL line.
Off The DSL line is down.
Internet
Green On The VMG has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the DSL
connection is up.
Blinking The VMG is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged mode.
Red On The VMG attempted to make an IP connection but failed. Possible causes
are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.
WAN
Green On The VMG has a successful 10/100/1000 Mbps Ethernet connection on the
WAN.
Blinking The VMG is sending or receiving data to/from the WAN at 10/100/1000
Mbps.
Off There is no Ethernet connection on the WAN.
Ethernet
Green On The VMG has a successful 10/100/1000 Mbps Ethernet connection with a
device on the Local Area Network (LAN).
Blinking The VMG is sending or receiving data to/from the LAN at 10/100/1000
Mbps.
Off The VMG does not have an Ethernet connection with the LAN.
WiFi 2.4G
WiFi 5G
Green On The 2.4G or 5G WiFi network is activated.
Blinking The VMG is communicating with 2.4G or 5G WiFi clients.
Amber Blinking The VMG is setting up a WPS connection with a 2.4G or 5G WiFi client.
Off The 2.4G or 5G WiFi network is not activated.
USB
Note: The USB LED is reserved for future development.