Chapter 1 VMG Introduction
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User’s Guide
27
Phone1,
Phone2
Green On A SIP account is registered for the phone port, and there’s no voice
message in the corresponding SIP account.
Blinking A telephone connected to the phone port has its receiver off of the hook or
there is an incoming call.
Amber On A SIP account is registered for the phone port and there is a voice message
in the corresponding SIP account.
Blinking A telephone connected to the phone port has its receiver off the hook and
there is a voice message in the corresponding SIP account.
Off The phone port does not have a SIP account registered.
Red On Registration to the network has failed.
WPS
Amber On WPS is enabled.
Off WPS is disabled.
Table 4 VMG3927-B50B LED Descriptions
LED COLOR STATUS DESCRIPTION
Power
Green On The VMG is receiving power and ready for use.
Blinking The VMG is self-testing.
Red On The VMG detected an error while self-testing, or there is a device
malfunction.
Blinking The VMG is uploading firmware.
Off The VMG is not receiving power.
DSL
Green On The ADSL line is up.
Blinking The VMG is initializing the ADSL line.
Amber On The VDSL line is up.
Blinking The VMG is initializing the VDSL line.
Off The DSL line is down.
Internet
Green On The VMG has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the DSL
connection is up.
Blinking The VMG is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged mode.
Red On The VMG attempted to make an IP connection but failed. Possible causes
are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.
WAN
Green On The VMG has a successful 10/100/1000 Mbps Ethernet connection on the
WAN.
Blinking The VMG is sending or receiving data to/from the WAN at 10/100/1000
Mbps.
Off There is no Ethernet connection on the WAN.
Ethernet
Green On The VMG has a successful 10/100/1000 Mbps Ethernet connection with a
device on the Local Area Network (LAN).
Blinking The VMG is sending or receiving data to/from the LAN at 10/100/1000
Mbps.
Off The VMG does not have an Ethernet connection with the LAN.
Table 3 VMG9827-B50A LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
