Chapter 1 Introduction
NWA5000 / WAC6000 Series User’s Guide
23
Figure 6 WAC6103D-I LEDs
The following table describes the LEDs.
Table 7 WAC6103D-I LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Red Slow Blinking (On for
1s, Off for 1s)
The WAC is booting up.
Green On
Red Off The WAC is ready for use.
Green On
Red On There is system error and the WAC cannot boot up, or
the WAC suffered a system failure.
Green Off
Red Fast Blinking (on for
50ms, Off for 50ms)
The WAC is doing firmware upgrade.
Green Off
Red Slow Blinking (blink
for 3 times, Off for 3s)
The Uplink port is disconnected.
Green Off
Red Slow Blinking (blink
for 2 times, Off for 3s)
The wireless module of the WAC is disabled or failed.
Green Off
Management Green On The WAC is managed by a controller.
Slow Blinking (blink
for 3 times, Off for 3s)
The WAC is searching (discovery) for a controller.
Off The WAC is in standalone mode.
To Next Page
Loading...
