ZyXEL Communications WAC6000 Series - Nwa5301-Nj

Chapter 1 Introduction
NWA5000 / WAC6000 Series User’s Guide
24
1.6.3 NWA5301-NJ
The LEDs automatically turn off when the NWA5301-NJ is ready. You can press the LED ON button
for one second to turn on the LEDs again. The LEDs will blink and turn off after two minutes.
WLAN Green On The antenna switch is set to “Ceiling” for the radio.
The 2.4 GHz WLAN is active.
Blinking The antenna switch is set to “Ceiling” for the radio.
The 2.4 GHz WLAN is transmitting or receiving data.
Amber On The antenna switch is set to “Wall” for the radio.
The 2.4 GHz WLAN is active.
Blinking The antenna switch is set to “Wall” for the radio.
The 2.4 GHz WLAN is transmitting or receiving data.
Off The 2.4 GHz WLAN is not active.
WLAN Green On The antenna switch is set to “Ceiling” for the radio.
The 5 GHz WLAN is active.
Blinking The antenna switch is set to “Ceiling” for the radio.
The 5 GHz WLAN is transmitting or receiving data.
Amber On The antenna switch is set to “Wall” for the radio.
The 5 GHz WLAN is active.
Blinking The antenna switch is set to “Wall” for the radio.
The 5 GHz WLAN is transmitting or receiving data.
Off The 5 GHz WLAN is not active.
UPLINK Amber/
Green
On Amber - The port is operating as a 100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The WAC is sending/receiving data through the port.
Off The port is not connected.
LAN Amber/
Green
On Amber - The port is operating as a 100-Mbps
connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The LAN port is sending/receiving data through the
port.
Off The LAN port is not connected.
Locator White Blinking The Locator is activated and will show the actual
location of the WAC between several devices in the
network.
Off The Locator function is off.
Table 7 WAC6103D-I LEDs (continued)
LED COLOR STATUS DESCRIPTION