ZyXEL Communications WAC6000 Series - Page 25

Chapter 1 Introduction
NWA5000 / WAC6000 Series User’s Guide
25
Figure 7 NWA5301-NJ LEDs
The following are the LED descriptions for your NWA5301-NJ.
Table 8 NWA5301-NJ LEDs
LABEL COLOR STATUS DESCRIPTION
PWR/SYS Amber Slow Blinking (On for
1s, Off for 1s)
The NWA is booting up.
Green On
Amber Off The NWA is ready for use.
Green On
Amber Slow Blinking (blink
for 3 times, Off for 3s)
The NWA is discovering an AP controller
Green On
Amber On The NWA failed to boot up or is experiencing system
failure.
Green Off
Amber Fast Blinking (On for
50ms times, Off for
50ms)
The NWA is undergoing firmware upgrade.
Green Off
Amber Slow Blinking (blink
for 3 times, Off for 3s)
The Uplink port is disconnected.
Green Off
Amber Slow Blinking (blink
for 2 times, Off for 3s)
The wireless module of the WAC is disabled or failed.
Green Off
PoE Green On Power is supplied to the yellow PoE Ethernet port
(LAN1).
Off There is no power supply.
WLAN Green On The WLAN is active.
Blinking The WLAN is transmitting or receiving data.
Off The WLAN is not active.
UPLINK Green On The port is connected.
Blinking The NWA is sending/receiving data through the port.
Off The port is not connected.
LAN1-3 Green On The port is connected.
Blinking The NWA is sending/receiving data through the port.
Off The port is not connected.