ZyXEL Communications WSQ60 - Web Configurator - Multy M1 (WSM20); Overview; Accessing the Web Configurator

Multy WiFi System User’s Guide
138
CHAPTER 5
Web Configurator – Multy M1
(WSM20)
5.1 Overview
This chapter describes how to access the Multy Device Web Configurator and provides an overview of
its screens.
The Web Configurator is an HTML-based management interface that allows easy system setup and
management through Internet browser. Use a browser that supports HTML5, such Mozilla Firefox, or
Google Chrome. The recommended screen resolution is 1024 by 768 pixels.
In order to use the Web Configurator you need to allow:
• Web browser pop-up windows from your device.
• JavaScript (enabled by default).
• Java permissions (enabled by default).
5.2 Accessing the Web Configurator
1 Make sure your Multy Device hardware is properly connected (refer to the Quick Start Guide).
2 Launch your web browser.
3 If the Multy Device is in Standard Mode (the default mode), enter "http://zyxelwifi.com or 192.168.212.1"
in the browser’s address bar.
If the Multy Device is in Bridge Mode, enter “http:// (DHCP-assigned IP)” in the browser’s address bar.
4 On the displayed login screen, log in using your myZyxelCloud username and password or the local
password.
Note: If this is the first time you are accessing the Web Configurator or if the device has been
reset, you must complete the setup wizard, see Chapter 4 on page 128.
Note: For setting and changing the local password, see Section 7.9 on page 165.