Chapter 9 Web Interface Tutorials – Multy M6E (WSQ65)
Multy WiFi System User’s Guide
203
You can now use the WPS feature to establish a WiFi connection between your notebook and the Multy
Device (see Section 9.2.2.1 on page 203). Now use the new security settings to connect to the Internet
through the Multy Device using WiFi.
9.2.2 Connecting to the Multy Device’s WiFi Network Using WPS
This section shows you how to connect a WiFi device to the Multy Device’s WiFi network using WPS. WPS
(Wi-Fi Protected Setup) is a security standard that allows devices to connect to a router securely without
you having to enter a password.
9.2.2.1 WPS Push Button Configuration (PBC)
This example shows how to connect to the Multy Device’s WiFi network from a notebook computer
running Windows 10.
1 Make sure that your Multy Device is turned on, and your notebook is within range of the Multy Device’s
WiFi signal.
2 Push and hold the WPS button located on the Multy Device until the WiFi or WPS LED starts blinking slowly.
Alternatively, log into the Multy Device’s Web Configurator, and then go to the Network Setting >
Wireless > WPS screen. Enable WPS and Method 1 PBC, click Apply, and then click the WPS button.
3 In Windows 10, click on the Network icon in the system tray to open the list of available WiFi networks.
To Next Page
Loading...
