XGS1210-12 / XGS1250-12 User’s Guide
15
Figure 6 Attach Rubber Feet
2.2.2 Wall Mounting
Do the following to mount your Switch on a wall.
1 Drill two holes on the wall at the distance of ‘D’ – see Figure 7 on page 15.
2 Insert screw anchors and screws (not provided) into the holes. Leave a small gap between the head of
the screw and the wall.
3 The gap must be big enough for the screws to slide into the wall mount holes and the power cord to run
down the back of the Switch.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the Switch with the connection cables.
4 Place the Switch so the wall mount holes line up with the screws. Slide the Switch down gently to fix it into
place.
Wall-mount the Switch with the Ethernet ports facing down and the
ventilation holes on the side.
Figure 7 Wall Mounting
Table 3 Wall Mounting Distance
DISTANCE ‘D’ BETWEEN MOUNTING HOLES
180 mm / 7.09 in
To Next Page
Loading...
