ZyXEL Communications XGS3700 Series - Link Aggregation Control Protocol

Chapter 15 Link Aggregation
GS3700/XGS3700 Series User’s Guide
149
15.5 Link Aggregation Control Protocol
Click in the Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See Section 15.2 on page 144 for more information on dynamic link
aggregation.
Figure 85 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 63 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do not configure this screen unless you want to enable dynamic link aggregation.
Active Select this checkbox to enable Link Aggregation Control Protocol (LACP).