ZyXEL Communications ZYAIR B-3000 - MAC Filter Summary

ZyAIR B-3000 Intelligent Wireless LAN Access Point
18
The following table describes the fields in this screen.
Table 4 Wireless : Edit ESS
LABEL DESCRIPTION
ESSID Enter a descriptive name (up to 32 alphanumeric characters) for identification
purposes.
This name is case sensitive.
Active Select this check box to activate this ESS.
VLAN ID Enter a number from 1 to 255. See the Configure VLAN section in this guide for
more information on VLAN.
ASCII Select this option to enter ASCII characters as the WEP keys.
Hex Select this option to enter hexadecimal characters for the WEP keys.
The preceding “0x” is entered automatically.
Unicast WEP key
Key 1 or Key 2 Key 1 or key 2 is used to encrypt unicast transmissions.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
You must configure both keys, but only one key can be activated at any one time.
The default key is key 1.
Broadcast/Multicast WEP key
Key 3 or Key 4 Key 3 or key 4 is used to encrypt multicast/broadcast transmissions.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
You must configure both keys, but only one key can be activated at any one time.
The default key is key 3.
MAC Filter Summary
If you select Multiple ESS in the Operating Mode field in the Wireless screen, the MAC Filter
Summary screen displays as shown when you click the MAC Filter tab.