ZyXEL Communications ZyWALL 2 Plus - Page 23

mbuf R + B
link link R + B list system mbuf link
pool <id> [type][num] R + B list system mbuf pool
status R + B display system mbuf status
disp <address>[1|0] R + B display mbuf status
cnt R + B
disp R + B display system mbuf count
clear R + B clear system mbuf count
debug [on|off] R + B
mode <router/bridg
e>
R + B switch router and bridge mode
pwderrtm [minute] R + B
Set or display the password error blocking
timeout value.
rn R
load <entry no.> R load remote node information
disp <entry no.>(0:working buffer) R display remote node information
nat <none|sua|full_feature> R config remote node nat
nailup <no|yes> R config remote node nailup
mtu <value> R set remote node mtu
save [entry no.] R save remote node information
pingcheck [on|off] U + R enable/disable WAN pingcheck
smt R + B not support in this product
stdio [second] R + B change terminal timeout value
time [hour [min [sec]]] R + B display/set system time
tos R + B
display R + B display all runtime TOS
listPerHost R + B display all host session count
debug [on|off] R + B turn on or off TOS debug message
sessPerHost <number> R + B configure session per host value
timeout R + B
display R + B display all TOS timeout information
icmp <idle timeout> R + B set idle timeout value
igmp <idle timeout> R + B set idle timeout value
tcpsyn <idle timeout> R + B set idle timeout value
tcp <idle timeout> R + B set idle timeout value
tcpfin <idle timeout> R + B set idle timeout value
udp <idle timeout> R + B set idle timeout value
gre <idle timeout> R + B set idle timeout value
esp <idle timeout> R + B set idle timeout value
ah <idle timeout> R + B set idle timeout value
other <idle timeout> R + B set idle timeout value
tempTOSDispla
y
R + B display temporal TOS records.
tempTOSTimeo
ut
[timeout value] R + B set/display temporal timeout value
trcdisp parse, brief,
disp
R + B monitor packets
trclog R + B
trcpacket R + B
syslog R + B
server [destIP] R + B set syslog server IP address
facility <FacilityNo> R + B set syslog facility
type [type] R + B set/display syslog type flag
mode [on|off] R + B set syslog mode
version R + B display RAS code and driver version
view <filename> R + B view a text file
wdog R + B
switch [on|off] R + B set on/off wdog
cnt [value] R + B display watchdog counts value: 0-34463