ENGLISH
7
ZyWALL USG 100
7 Troubleshooting
Port Interface Zone IP Address and DHCP Settings Suggested Use With Default Settings
P1, P2 wan1,
wan2
WAN DHCP clients Connections to the Internet
P3, P4, P5 lan1 LAN1 192.168.1.1, DHCP server enabled Protected LAN.
P6 ext-wlan WLAN 10.59.0.1, DHCP server enabled Wireless access points
P7 dmz DMZ 192.168.3.1, DHCP server enabled Public servers (such as web, e-mail and
FTP)
AUX aux None None Auxiliary modem
CONSOLE n/a None None Local management
Label Type Description
USB USB Connect a (USB) 3G wireless card to access the Internet through a 3G network. At
the time of writing, you can use the Huawei E220.
P1~P7 RJ-45 Use 8-wire Category 5e or above Ethernet cables to connect routers, switches,
computers, routers, access points, and so on.
AUX RS-232 Use an RS-232 console cable to connect dial backup/dial-in modem.
CONSOLE RS-232 Use an RS-232 console cable to connect a local computer for command-based
management.
EXTENSION
CARD SLOT
PCMCIA Insert a wireless LAN card to use the wireless LAN feature. At the time of writing, you
can use ZyXEL’s G-170S wireless card. You can optionally insert a 3G wireless card to
access the Internet wirelessly via a 3G network. At the time of writing, you can use a
Sierra Wireless AC850 or AC860 3G wireless card.
Problem Corrective Action
None of the LEDs
turn on.
Make sure that you have the power cord connected to the ZyWALL and plugged in to an
appropriate power source. Make sure you have the ZyWALL turned on. Check all cable
connections.
If the LEDs still do not turn on, you may have a hardware problem. In this case, you should
contact your local vendor.
To Next Page
Loading...
